Materials Handling Electrical power UNIT 1
Common Description
This energy unit is created for that fork lift field, consisting of really productive gear pump, DC motor, guide increase and reduced valve, tank, ect. The up and down motion are controlled through the lever in the guide release valve, and that is outfitted with an electrical switch to activate the motor. The lowing speed is managed from the pressure compensated movement management valve.
Special Notes
one. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean the many hydraulic parts concerned ahead of installation of the electrical power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst, which should really also be clean and cost-free of impurities, N46 hydraulic oil is proposed .
four. Oil shifting is required just after the original a hundred operation hours, afterwards once each and every 3000 hrs.
5. The energy unit shown is intended to be mounted horizontally.

Materials Dealing with Electrical power UNIT 2
Standard Description
This power unit characteristics energy up gravity down circuit. Activate the start out solenoid to begin the motor to lift the machine. The lowing motion is activated from the solenoid valve together with the decreasing velocity controlled from the stress compensated movement management valve. Products of this series could be extensively utilized in the field of logistic units for instance fork lift, mini lift table, etc.
Unique Notes
1. The duty of this energy unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean each of the hydraulic components concerned prior to mounting the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst,which must also be clean and free of charge of impurities, N46 hydraulic oil is encouraged .
four. Oil modifying is required just after the preliminary 100 operation hours,afterwards after each and every 3000 hrs.
five. The energy unit really should be mounted horizontally.